Catskill Craftsmen 51537 - Manual (Page 10)

STEP 11
Install Casters
A. Tap in caster sockets with a hammer until
teeth are in the wood. Don’t pound flat or
wheels won’t enter. Locking casters usually
go on front - seat with sharp downward stroke
with hammer hitting the metal wheel frame.
Magnet
5/8” Pan Head Screw
2 Used
in this step
STEP 10
Install Magnet
A. Stick magnet to magnet plate on right door.
B. With left door open, close the right door. The magnet should be positioned over the wooden block
on the bottom of the top front brace. Hold the magnet in place with your thumb, and open the right
door. The magnet will be in the correct position on the block. Mark your holes with a pencil.
C. Secure magnet with the two pan head screws in the magnet packet. Center screws in the slots in
the magnet . This will allow adjustment later, if needed.
NOTE: No pilot holes in block, as softwood!