Step 15, Step 16 – Catskill Craftsmen 51524 User Manual

Page 11

STEP 15

Install Shelves/Disks

A. Upright unit and insert drawer. If

drawer front hits the top front brace,

tap brace down. Take bottom shelf

(no edge banding) and place it on

the set of back pins as shown. Close

doors and shelf will drop into place.

DO NOT FORCE!
B. Tap two 1” pins into each side

panel to hold middle shelf, making

sure the pins on both sides are in the

same relative position. To remove a

pin, use pliers or a claw hammer.
C. Place middle shelf, edge banding

out, on pins.
D. Once drawer fit is correct,

re-tighten screws and insert wooden

disks into sides.

Edge

Banding

4 used in

this step

1” LONG 3/16” DIA. STEEL PIN

STEP 16

Assemble Backsplash

Attach the backsplash to the back

edge of the table top with 1 1/4” #8

screws in three places as shown.

3 used

in this step

1 1/4” #8 PHILLIPS FLAT HEAD SCREW