Catskill Craftsmen 51524 - Manual (Page 10)

Magnet
5/8” Pan Head Screw
2 Used
in this step
STEP 13
Attach Magnet to Magnet Block
A. Stick magnet to magnet plate on right door.
B. With left door open, close the right door. The magnet should be positioned over the wooden block
on the bottom of the top front brace. Hold the magnet in place with your thumb, and open the right
door. The magnet will be in the correct position on the block. Mark with a pencil.
C. Secure magnet with the two round head screws
in the magnet packet. Center screws in the slot in
the magnet. This will allow adjustment later,
if needed.
Magnet
5/8” Pan Head Screw
2 Used
in this step
Magnet
5/8” Pan Head Screw
2 Used
in this step
ILLUSTRATION 13
STEP 14
Install Casters
A. Insert and tap caster sockets with a
hammer until the teeth grab the wood.
DON’T POUND SOCKET FLAT OR
CASTER SHAFT WILL NOT ENTER.
B. Insert casters and seat by pushing
straight downward with the heel of your
hand, or tap into place with a hammer.
Don’t be afraid to give them a good
downward whack on the solid metal part
of the caster!
Note: Locking wheels usually go on the
front!
ILLUSTRATION 14