Catskill Craftsmen 1533 - Manual (Page 8)

STEP 9
A. Take the top front brace ( with magnet block ), insert the pins in the brace
ends into the slots on the inside of the front legs and slide down until the
brace rests on the bottom of the drawer front. The pin holes for the door
pins will be up.
B. Twist drawer dowel into the 1/2” dia.
hole on the inside of the brace under
the magnet block.
C. BEFORE securing brace with
1 3/4” machine screws/hex nuts,
raise brace approximately 1/8”
before tightening ( or use a
couple of dull kitchen knives
as spacers between the brace
and the top edge of the
drawer front. ) This will allow
the drawer to open easily
when unit is uprighted.
Side Panel Leg
Inside Brace
Countersunk Hole in Leg
( disk goes in this hole to
hide bolt head! )
Nut Access Hole
Hex Nut
1 3/4” Phillips Flat Head Bolt (8)
2 Used
in this step
10-24 Hex Nut (8)
2 Used
in this step
ILLUSTRATION 9A
ILLUSTRATION 9B