Catskill Craftsmen 1533 - Manual (Page 4)

1 1/4” Phillips Flat Head #8 Screw (12)
4 Used in this step
Attach a table top stick to the
top of each side panel using
1 1/4” #8screws. The countersunk
holes (reamed out) in the
stick are positioned as in
illustration 1. Sticks should
be flush with top of panel.
STEP 1
ILLUSTRATION 1
STEP 2
A. Lay back panel flat on a smooth surface with holes up.
B. Decide at this point if you want the handle/towel bar on
the right or the left side of the cabinet as they are
interchangeable. We placed the handle/towel bar on the
right for these instructions.
C. Attach side panels with 1 3/4” machine screws (bolts)
and hex nuts. After inserting bolts(s) thru the holes in the
side panels, thru the holes in the long edges of the back
panel, place a hex nut on the tip of your finger, align nut
with bolt and tighten.
D. Look ahead to step 5 which shows side panels
attached to back panel.
NOTE: Back panel is flush with bottom of side
panels. Back panel is 1” shorter than side
panels which leaves gap for drop leaf hinges.
1 3/4” Phillips Flat Head Bolt (8)
4 Used
in this step
10-24 Hex Nut (8)
4 Used
in this step
ILLUSTRATION 2
STEP 3
ILLUSTRATION 3
5/8” Phillips Flat Head #8 Screw (23)
20 Used in this step
Assemble top by placing the top and the drop
leaf upside down on a smooth flat surface.
Install hinges using 5/8 #8 screws. The longer
part of the hinge goes on the drop leaf with
the short part on the cart top. Fasten the
drop leaf supports using 5/8 #8 screws.
See illustration 3
STEPS 3 - 14 WILL BE ACCOMPLISHED WITH THE
UNIT TOP UPSIDE DOWN ( INVERTED), BUILDING
UPWARD TOWARD THE BOTTOM/CASTER END!
BE CAREFUL AS PART DESCRIPTIONS ARE BASED
ON AN UPRIGHT, COMPLETED UNIT!