Catskill Craftsmen 1533 - Manual (Page 11)

STEP 14
A. Insert and tap caster sockets with
hammer until the teeth grab the wood.
DON’T POUND SOCKET FLAT
OR CASTER SHFT WILL
NOT ENTER.
B. Insert casters and seat by
pushing straight downward
with heel or your hand, or tap
into place with a hammer.
Don’t be afraid to give them
a good downward whack on
the solid metal part of the
caster!
C. Locking wheels usually go
on back, but can go diagonally
or on the front if cart is moved
a lot.
ILLUSTRATION 14
STEP 15
A. Upright Unit. Take care when
you upright the unit so that the
drop leaf is support with your
hand. Take bottom shelf
( no edge banding )
and place it on the
set of back pins.
Close doors and
shelf will drop into place.
B. Decide on position of middle
shelf, then tap two 1” pins into
each side panel, making sure
the pins on both sides are in
the same relative position. To
remove a pin, use pliers or
claw hammer.
C. Place middle shelf, edge
banding out, on pins.
D. Tap remaining wooden disks
into sides.
ILLUSTRATION 15