ArtDio IPE 1000 User Manual
Page 29

29
agent.
Reset system, [Y]es or [N]o? Yes
Step 7: Configuring the Prefix for the gateway
The prefix for the gateway should be assigned by the network administrator and configured to the
device. It will be carried in the routing messages to notify the master device of its prefix for other
gateways to route its calls.
Command: PBX GATEWAY (routing)#prefix
PBX GATEWAY (routing)#prefix 99
PBX GATEWAY (routing)#
Step 8: Configuring the Internal Call Access code for the gateway
Command: PBX GATEWAY(routing-code)#internal_ac for this gateway> PBX GATEWAY(routing)#code PBX GATEWAY(routing-code)# PBX GATEWAY(routing-code)#internal_ac * Step 9: Configuring the Extension Number Length of the PBX Command: PBX GATEWAY(routing-code)#extension_len of PBX> PBX GATEWAY(routing)#code PBX GATEWAY(routing-code)# PBX GATEWAY(routing-code)#extension_len 3 (System must be restarted in order for the new configurations to take effect) Using the Phone Set Interface (please refer to Phone Set Interface Configuration Procedures for more detailed information) Step 1: Take the handset off the phone. Step 2: After hearing the dial tone, dial the PROG Access Code. Step 3: Enter the Password. Step 4: Enter code "06" to begin configuring the IP address of the master gateway. Step 5: Enter the IP address for the master gateway as "0", "*", "0", "*", "0", "*", "0"