Additel 949 Hydraulic High Pressure Calibration Pump User Manual - Manual (Page 2)

DIGITAL PRESSURE CALIBRA TOR
Units
A 0 25 50 75 100 0 25 50 75 100
bar bar
A
SW V mA COM 24V SW V mA COM 24V SW V mA COM 24V SW V mA COM 24V
Basic Operation
Connection
dial gauge pressure switch pressure transmitter flexible hose
D B
E F G
A B
Maintenance
Pressure Gauge Pressure Gauge
Bar 32
64 96
128
160
C
②open
③close
⑤open
Pressure Gauge Pressure Gauge Bar 32
64 96
128
160
Pressure Gauge Pressure Gauge Bar 32
64 96
128
160
DIGITAL PRESSURE CALIBRATOR
Units
A 0 25 50 75 100
bar bar
DIGITAL PRESSURE CALIBRATOR
Units
A 0 25 50 75 100
bar bar
Pressure Gauge Pressure Gauge Bar 32
64 96
128
160
Pressure Gauge Pressure Gauge Bar 32
64 96
128
160
③close
①close
DIGITAL PRESSURE CALIBRATOR
Units
A 0 25 50 75 100 0 25 50 75 100
bar bar
Pressure Gauge Pressure Gauge Bar 32
64 96
128
160
Pressure Gauge Pressure Gauge Bar 32
64 96
128
160
②open
④open
DIGITAL PRESSURE CALIBRATOR
Units
A 0 25 50 75 100
bar bar
Pressure Gauge Bar 0.8
0.6 0.4
0.2
0 -1
Pressure Gauge Bar 0.8
0.6 0.4
0.2
0 -1
②close
④open
①open
DIGITAL PRESSURE CALIBRATOR
Units
A 0 25 50 75 100
bar bar
Pressure Gauge Bar 0.8
0.6 0.4
0.2
0 -1
Pressure Gauge Bar 0.8
0.6 0.4
0.2
0 -1
①close
DIGITAL PRESSURE CALIBRATOR
Units
A 0 25 50 75 100
bar bar
Pressure Gauge Bar 0.8
0.6 0.4
0.2
0 -1
Pressure Gauge Bar 0.8
0.6 0.4
0.2
0 -1
②open
Pressurizing procedure Depressurizing procedure
① Always keep valve(#4)
open during operation
④a few turns ② Pre-pressurizing
④ high-pressure
Pressurizing
Note: Skip step for dial gauge
calibration in a narrow
pressure range
③
① Depressurizing
③ Depressurizing
③Fully turn
⑤Fully turn
②Vacuum ①back to atmosphere
Open to atmosphere (Venting)
and Zeroing
Vacuum procedure Back to atmosphere
②Fill media
①Open reservoir
cover vent valve (#4)
① Open drain valve (#6)
② Collect media using a container
③ Open reservoir cover
vent valve (#4)
⑤ Remove the
reservoir(#5)
④ Unscrew with
hex wrench
Fill media Drain and Clean
Remark:
A Additel has made a concerted effort to provide
complete and current information for the proper
use of the equipment. The product specifications
and other information contained this manual are
subject to change without notice.
B :
: Above pictures are just for reference.
Additel Corporation, USA
www.additel.com
Note: Gauge positions are exchangeable. If only one device under test (DUT) is connected, the third connector on pump should be closed by a plug provided. ①
② Connect the gauges on pump by fingers, tighten the connectors using two wrenches.
Note: Please degas after filling media liquid,
in case hard to generate pressure.
Degas