WEN 4205 8 inch Drill Press with Laser - Manual (Page 17)

17
Assembly and adjustments (continued)
WARNING: DO NOT STARE DIRECTLY AT THE LASER BEAM! A hazard may
exist if you deliberately stare into the beam. Please observe all safety rules as follows:

The laser shall be used and maintained in accordance with the manufacturer's instructions.
 Never aim the beam at any person or an object other than the workpiece.

Do not project the laser beam into the eyes of others.
 Always ensure the laser beam is aimed at a workpiece with out reflective surfaces as the laser
beam could be projected into your eyes or the eyes of others.
Laser switch
The laser switch is located on the left side of the drill press housing.
Adjust the laser line (Fig. 14)
1. Place a workpiece on the table.
2. Turn the laser switch to the ON position.
3. Lower the drill bit to meet the workpiece (2). The two laser lines should cross where the drill
meets the workpiece.
4. If the laser needs to be adjusted:
1. Using a screwdriver, turn the laser adjustment screws counterclockwise.
2. Move the laser light housing until the two lines intersect where the drill meets the
workpiece. DO NOT stare directly at the laser lines.
5. Re-tighten the adjustment screws.