WEN 70711 10 inch Sliding Compound Miter Saw Manual - Manual (Page 9)

9
GROUNDING INSTRUCTIONS
Tool with three (3) wire grounding plugs (a-in illustration on page 10) is intended for use on a circuit
that has an outlet that looks like the one illustrated in Sketch (B) . an adapter (d) may be used to
connect this plug to a two (2) pole outlet (C) if a properly grounded outlet is not available . The
temporary adapter should be used only
until a properly grounded outlet can be
installed by a qualified electrician . The
green colored rigid ear or wire extending
from the adapter must be connected to
a permanent ground such as a properly
grounded outlet box .
UNPACKING
WARNING - to prevent accidental starting that could cause possible serious
personal injury, assemble all parts to your saw before connecting it to power sup-
ply . Saw should never be connected to power supply when you are assembling
parts, making adjustments, installing or removing blades, or when not in use .
WARNING - if any parts are missing, do not operate this tool until the missing
parts are replaced . Failure to do so could result in possible serious personal injury .
• do not discard the packing materials until you have carefully inspected the saw, identified all parts,
and satisfactorily operated your new saw
NOTE: if any parts are damaged or missing, do not attempt to plug in the power cord and turn the
switch on until the damaged or missing parts are obtained and are installed correctly .