beautypg.com

WEN 70711 10 inch Sliding Compound Miter Saw Manual User Manual

Page 11

background image

11

• Make sure the blade flanges are properly installed .
• Be sure the arbor bolt and washer are properly installed and tightened .
• ensure all clamps and locks are tight . Verify there is no excessive play in any parts .
• allow the blade to reach full speed before cutting .

Do not cut freehand
• The workpiece should be tight against the fence . Verify the workpiece will not rock or twist when

it’s being cut . The area between the workpiece and the saw must be free from debris .

• Make sure there is no gap between the workpiece, fence and base of the saw . a gap could allow

the workpiece to move when it’s being cut .

• use clamps, fixtures or other devices to hold an unstable workpiece .

Do not cut more than one workpiece at a time
• allow room so the cut-off workpiece can move after it’s cut . it could create a hazard by becoming

wedged against the blade .

Be very careful when cutting odd shaped, extremely large or very small workpieces
• plan your work so an odd shaped workpiece cannot slip or pinch the blade . when cutting material

like molding, it must lie flat or be held by a fixture . do not allow the material to rock, twist or slip .

• Secure sagging workpieces with sawhorses, tables or other additional supports .
• do not cut small workpieces that you must hold closer than 4 inches (102 mm) from the blade .
• properly support round material when cutting . dowel rods and tubing have a tendency to roll while

being cut . This could allow the blade to “bite” into the material causing a hazardous condition . Hold

round material in place using clamps or other fixtures .

• inspect the workpiece for nails or other foreign objects before it is cut .
• do not allow anyone to stand behind the saw or close to the workpiece where debris can be

thrown .

• operate your saw in a clear, safe environment .
To avoid contact with a rotating blade
• do not wear gloves .
• do not wear loose clothing or jewelry .
• Tie back long hair .
• Roll long sleeves above the elbow .

To avoid injury from accidental starting of saw
• unplug the power cord from the electrical outlet .
• disconnect the lower blade guard .