WEN 70711 10 inch Sliding Compound Miter Saw Manual - Manual (Page 15)

15
Handle Latch
Components of a Miter Saw
ASSEMBLY
Attaching the Extension Supports and Miter Lock Handle
1 . insert the ends of the extension
Supports into the holes in the sides of the Base . Tighten the wing Screws to hold the extensions in
place . The upper edge of the extensions will be level with the surface of the saw . This provides a
wider base for the work material to rest on .
2 . Thread the Miter lock Handle into the opening of the miter handle until securely in place .
Attaching the Dust Collection Bag
3 . The dust Collection Bag slips over the dust outlet behind the Blade Housing assembly . Sawdust
created by cutting is captured in the bag .
MOUNTING THE SAW
The Miter Saw must be mounted on a support before use . This may be a commercially available
support or home made saw table . There are bolt holes provided in each of the four legs of the base .
These should be firmly mounted using bolts (not included) to your saw stand or saw table (not
included) . This will help prevent tipping or movement of the saw, preventing injury . also, the use of a
saw table will make it easier to efficiently handle work materials and make more accurate cuts
Arbor Lock