WEN 70711 10 inch Sliding Compound Miter Saw Manual - Manual (Page 12)

12
• install or remove the blade .
• perform maintenance or make adjustments .
To avoid injury from electrical shock
• do not touch the metal blades on the power cord plug when removing or installing the plug into an
electrical outlet .
To avoid injury from a fire hazard
• do not operate the saw near flammable liquids, vapors or gases .
When Operating Your Miter Saw
To avoid injury from unexpected saw movement
• use the saw on a firm level surface with adequate space for handling and supporting the work-
piece .
• Be sure the saw cannot move when operated . Secure the saw to a workbench or table with wood
screws, or bolts, washers and nuts .
Before moving the saw
• unplug the power cord from the electrical outlet .
• lock the handle in the down position using the handle latch .
To avoid back injury
• obtain help when it is necessary to raise the saw more than 10 inches (254 mm) .
• Bend your knees when lifting the saw .
• Carry your saw by the carrying handle or base . do not carry your saw by the power cord or the
trigger handle . Carrying the saw by the power cord could cause damage to the insulation or the
wire connections resulting in electric shock or fire .
Whenever Your Miter Saw is Running
• do not make a careless error . Just because you operate the saw frequently, a neglectful moment
can cause a severe injury .
• do not lubricate the blade while it is spinning .
Prior to cutting a workpiece
• Test the operation of your saw . if you feel excessive vibration or hear an unusual noise,
immediately stop operating the saw . Correct the problem before continued use .
WARNING