Wellsaw 1316S - Manual (Page 7)

5
Notes on Sawing
It is widely recognized that a proficient operator is a
key to optimum bandsawing. He makes certain the
machine is properly maintained and adjusted for
dependable operation. He carefully sets up each
cutting job to prevent damage to the machine and
obtain the best performance from the equipment.
Experienced blade dealers can be very help-ful in
selecting the grade and proper tooth blade for each
sawing job. All blades should be straight, have sharp
teeth with uniform set, and be “broken in” at a
reduced feed rate to obtain good cutting performance
and blade life.
Every cutting situation has special characteristics
requiring some experimentation to determine which
blade, speed and feed rate will achieve the most
satisfactory result. Cutting charts indicate a good
starting point, but must be modified by direct
experience if optimum performance is desired.
Here are some helpful pointers for adjusting speed
and feed for good cutting performance.
1. Make sure the saw is cutting a good chip from the
workpiece.
2. Watch for blue chips or excessive “smoke”
indicating heat in the cut which could damage the
blade or work harden the material being cut.
3. Watch for excessive vibration or chatter marks on
the cut-off piece indicating possible damage to the
saw teeth by “hammering”.
4. Check the cut-off piece for flatness. A dull blade
or excessive feed will produce a “belly” in the cut.
5. Inspect the blade for worn, rounded or shiny
cutting edges. Avoid force cutting which will allow
chips to “weld” to saw teeth and eventually cause the
teeth to be stripped off the blade.
6. When experimenting, start with a slow speed and
feed rate. Gradually increase blade speed and then
feed pressure by small amounts until adverse effects
are noted. You can then set the speed and feed at a
reasonable level for continuous cutting. Remember
that blade speed and feed pressure must be balanced
to keep cutting a good chip.
Trouble Shooting
Premature Dulling of Blade Teeth
1. Feed rate too high or low. Check recommendation.
2. Blade speed too slow or too fast.
3. Faulty material; heavy scale, hard spots, etc.
4. Verify material analysis.
5. If coolant flow is not covering saw teeth, increase coolant flow
rate.
6. If saw is vibrating in cut, reduce blade speed or increase feed
rate.
7. Chipped or broken tooth may be lodged in cut.
8. “Chip welding” caused by improper feed and speed.
9. Incorrect coolant mixture.
10. Incorrect blade selection
11. Improper break-in of new blade. New blades should be run
initially with reduced feed pressure for approximately 50 to
100 square inches.
12. Saw blade teeth may be hitting blade guides. Check for
proper blade size.
Saw Blade Vibration
1. Incorrect blade speed for material.
2. Blade tension insufficient.
3. Back-up bearing may be worn.
4. Incorrect choice of saw tooth pitch.
5. Incorrect coolant mixture.
6. Incorrect feed setting. Increase feed.
7. Workpiece not firmly clamped in vice.
8. Worn or improperly adjusted saw guides. Check and make
necessary adjustments.
Blade Teeth Chipping or Ripping Out
1. Blade pitch too coarse. Use a fine pitch saw blade on thin work
sections.
2. Improper break-in of new blade. Do not start a new blade in an
old cut.
3. Work piece not held firmly enough. Clamp work securely.
4. Introduce cooling if it is not being used.
5. Faulty material; scale or hard spots.
6. Blade gullets may be loaded. Use higher viscosity lubricant or
coolant.
7. Blade speed and feed may need adjustment.