Wellsaw 1316S - Manual (Page 11)

9
Operation of the Swivel Feature for
Miter Cutting
The angle of the cut is adjustable from 0° (90°) to
60°. The angle is indicated by a pointer at the back
of the chip pan and a large scale on the edge of the
cutoff turntable. The saw head is locked into
position by means of a control rod and locking
block. There is a 0° stop on the back of the saw
bed. DO NOT ADJUST THIS STOP.
To adjust the angle of the cut, loosen the angle lock
handle, pull the saw head, while lining up the
pointer to the desired angle shown on the scale.
Then gently tighten the handle. The lock requires
very little pressure to hold the head in place. DO
NOT OVER TIGHTEN.
Stock Stop Feature
The saw is equipped with an adjustable stock stop
for use when making repeated cuts of the same
length. The stop length is adjusted with the same
type of lock used on the saw head angle lock. The
stop can be adjusted width-wise using the “T”
handle on the lower portion of the support. The
stop mechanism can also be swung completely out
of the way. To do this, loosen the “T” handle two
turns, lift up on the stop and let it down behind the
saw.
Recommended Service
Kits for Insurance
Against Downtime
1 year
100133-004 Rotary Blade Brush 1 reqd.
For serial numbers before 6090 and after 6272
2 year
100416-001 Bearing 4 reqd.
152153 Top Carbide Guide 2 reqd.
105454-005 VS Belt 1 reqd.
100133-004 Rotary Blade Brush 1 reqd.
100166-450 Blade Brush V Belt 1 reqd.
106317 Fixed Carbide Guide 4 reqd.
101645-FP Drive Pinion 1 reqd.
For serial numbers between 6090 and 6272
2 year
100406-001 Bearing 2 reqd.
100417-001 Bearing 2 reqd.
100416-001 Bearing 2 reqd.
152153 Top Carbide Guide 2 reqd.
105454-005 VS Belt 1 reqd.
100133-004 Rotary Blade Brush 1 reqd.
100166-450 Blade brush V Belt 1 reqd.
106317 Fixed Carbide Guide 4 reqd.
101645-FP Drive Pinion 1 reqd.