Wellsaw 1316S - Manual (Page 12)

10
Maintenance
Caution: Disconnect the electrical supply and press
emergency STOP button before performing any
maintenance. DO NOT service the Frame Hydraulic
Cylinder or Down Feed Valve unless the frame is in
the DOWN position or resting on a mechanical stop,
such as a block of wood.
D a i l y
1. Keep the saw clean and free of chips.
2. Maintain the coolant level and keep the
coolant tank and filter clean of chip accumulation
or sludge.
Monthly
1. Check, adjust and replace blade brush as
needed.
2.
Lubricate drive gears
3. Inspect carbide guides and bearings.
4. Inspect drive belt.
5. Clean coolant tank and filter as needed.
Annually
1. Check hydraulic oil level.
2. Replace guide rollers and carbide inserts.
3. Inspect gear box. Lubricate as needed.
Lubrication
Correct and adequate lubrication is a very
important factor in determining the life and service
of your Wellsaw. It is essential that all dust, dirt,
chips,
etc. be
thoroughly removed before lubricating the saw.
The following lubrication recommendations cover
usual saw applications. Heavy use and hostile
environments may indicate more frequent
lubrication for best saw performance.
Vise Screw, Ring Gear, Drive Pinion
1. Inspect Monthly.
2. Use Anti-Seize on Vise Screw.
3. Use Extreme-Pressure Open Gear Lube
sparingly on Ring Gear and Drive Pinion
Gear Case
1. Inspect after 3 years (6,000 hours).
2. Use Mobilgrease XHP 220 or equivalent.
3. Viscosity: Heavy Grease, drop point 550EF
4. Military Specification: None
Hydraulic Cylinder
1. Inspect annually. Fill to top of plug. Drain and
replace every 5 years (10,000 hours).
2. Fill with Mobil Velocite Oil #6 or equivalent.
3. Viscosity at 100EF: SUS 57-61.
4. Military Specification: None.
M o t o r
1. Inspect annually. Re-lubricate every 2 years
(4,000 hours) 1 to 2 full strokes.
2. Use Shell Dolium R or equivalent.
3. Viscosity: Heavy Grease, drop point 219EC.
4. Military Specification: None.
Parts Ordering
For your convenience:
When contacting your Wellsaw supplier or the Company for parts or service, it is essential that you
have your saw Model, Serial Number and Purchase Date available.
Jot them down here for handy reference.
Model:
Serial Number:
Purchase Date: