Wellsaw 1316S - Manual (Page 17)

Rite Tensioning Device®
Caution:
The Rite Tension ® blade tensiong device has
been factory calibrated for your saw.
When re-tightening or replacing a blade, the 'T'
handle must be turned counter-clockwise at least
six turns to reset the Rite Tension ® mechenism.
1 150075 Blade Tensioning Ass'y
(includes items 2 thru 17 & 27)
2 101184 Take Up Screw Handle
3 100053-005 Roll Pin, 3/16 x 1
4 100030-007 Flat Washer, 1/2
5 100410-001 Thrust Bearing
6 150068 Bearing Housing
7 100116-007 Belleville Washer (2 req'd)
8 150074 Take Up Screw (includes items 2 & 9)
9 100052-026 Dowel Pin, 3/16 x 11/16
10 150069 Turn Counter
11 100136-006 Spring, Large Diameter
12 100136-001 Spring, Small Diameter
13 100000-010 Machine Screw, 8-32 x 5/16 (2 req'd)
14 150067 Blade Tension Housing
15 100034-008 Set Screw, 1/4-20 x 1/4
16 150070 Tension Adjuster
17 155068 Swivel Nut
18 150190 Tensioner Support
19 100008-072 Cap Screw, HH 5/16-18 x 3/8 (2 req'd)
20 100004-013 Cap Screw, HH 5/16-18 x 5/8 (4 req'd)
21 100025-002 Lock Washer, 5/16 (4 req'd)
22 B-046 Slide Block Guide, (2 req'd)
23 101164 Slide Block
24 B-010 Wheel Adjusting Block
25 100004-019 Cap Screw, HH 5/16-18 x 1-1/8 (4 req'd)
26 102360 Spacer (4 req'd)
27 098030-004 Collar, w/set screw
used for serial #s before 30005 and after 30020
for serial numbers between, use next page.
17