Spectra Precision Survey Pro v4.2 GPS - Manual (Page 11)

Survey Pro GPS Quick Start Guide 9
rover receiver, you will proceed directly to the Set Rover
screen. If you choose an Ntrip rover, you are prompted to
select an Ntrip service, then you proceed to the to the Set
Rover screen.
Select Ntrip Service
When using an Ntrip rover, Survey Pro opens the internet
connection, queries the GPS base server for the available
Ntrip services, and displays these services in a list. Pick a
service and tap Connect > to proceed to the Set Rover screen.
Set Rover
Measure the rover antenna height, then tap Set>. The
receiver will be put in RTK rover mode, and will monitor the
data link until it receives the base reference position. Survey
Pro will check the point database for a matching point. If you
are using a remote base, we will find a matching point or
prompt you to store a new point. If you are using the base
station you just set in the previous step, then this check
serves as error detection.
If you have a Recording Interval set, a file will be opened to log
raw GPS data for post processing. This file will be opened for
stop and go sessions, so the antenna heights and point names
will be written to the file simultaneously with each RTK point
occupation.
Start GPS Survey – Solve Localization
You need to solve a localization adjustment whenever you
start a survey from an autonomous GPS position. Step one is
to use the Control Points screen to collect GPS measurements
on points with known local coordinates. Step two is to use the
Solve Localization wizard to calculate the localization
adjustment parameters. You can also tap Start Now> to
begin surveying right away with a temporary localization
adjustment.