Spectra Precision Survey Pro v4.6 Basic GPS - Manual (Page 21)

Survey Pro Basic GPS Quick Start Guide 19
¾ How to perform stop and go data collection with the
EPOCH25 rover.
¾ What to do with the receiver’s data files after the survey.
Data collection for post processing involves storing GPS raw
data to a file on the receiver’s internal memory. Raw data
from multiple receivers is combined on the PC and then
software is used to process the base line measurements. This
section describes:
Note: If you wish to log post processing data simultaneous
with RTK data collection, please see the previous section.
Post Processing Settings
You can use the Job > Settings > Post Process screen to select
a special layer for post processing points, and to turn on the
Session Monitor
to warn you if data collection criteria is
exceeded during post processing sessions.
Start Receiver Recording
To open a data file and begin logging GPS raw data, go to the
Survey
> Post Processing screen and select the desired
Recording Interval
.
Choose Start Static > if you intend to leave the receiver
stationary over a point for the entire session. Choose
Start Stop/Go > if you intend to move around with the
receiver and stop on data collection points.
If an antenna height is already known, it will be entered for
you, otherwise enter the antenna height and enter the site ID
and description. If you start a static file, the Static Receiver
Session screen is opened. Tap Apply to write the information
to the post processing file. You can remain connected to the
receiver to monitor the entire session, or you can leave it to
log the data file unattended. If you start a stop and go file,
the Static Receiver Session screen is opened for post
processing data collection as described below.