SnowEx VSS-3000 - Manual (Page 45)

© Trynex International 2010 L1506 1 — 45
Troubleshooting
Loose electrical connections.
Blown Fuse.
Pump Seized.
Poor electrical connections.
Electrical short.
Controller failure.
Empty tank.
Full strainer.
Pump not running.
Obstructed nozzle.
Whenever service is necessary, your local SnowEx Dealer knows your Sprayer best. Take your Sprayer to your local dealer for
any maintenance or service needs on your unit. If this is not possible, the Troubleshooting Guide below may assist you in
identifying the problem.
First read all warning instructions and safety messages before servicing your Sprayer.
Preliminary Checks
• Be sure all electrical connections are tight and clean.
• Be sure nothing is obstructing the nozzles.
Pump doesn’t run.
Controller shut down.
Liquid not spraying.
Check all connections.
Replace fuse.
Replace pump.
Clean or replace connectors.
Use dielectric grease.
Check electrical connections.
Check for bare wires.
Replace controller.
Fill tank.
Clean or replace element.
Refer to Problem 1.
Remove and clean.
PROBLEM POSSIBLE CAUSE SOLUTION