SnowEx VSS-3000 - Manual (Page 21)

© Trynex International 2010 L1506 1 — 21
Model # VSS-1000
Electrical System
VSS 1000 WIRING INSTRUCTIONS
Step 1: First, install switch at desired location.
Step 2: Run spreader/vehicle harness from the rear of vehicle to switch area. Attach the female spade red wire to the switch. Leave the
black wire for Step 5.
Step 3: Route the power harness from the battery to the switch/control.
Step 4: Attach the red lead to the positive side of the battery and the black lead to the negative side of the battery.
Step 5: Attach the female spade red wire on switch terminal. Using 3" double female black wire jumper, attach the black wire from the
power harness to the black wire of the vehicle harness.
Step 6: Install rubber weatherproof boot on switch before finishing installation.
Step 7: Insert dielectric grease on terminals of SAE plug at rear of vehicle.
20
AMP
BATTERY
DOUBLE FEMALE
3" JUMPER
Key Part No. Description Qty.
D 6184 On/Off Switch 1
D 6406 Rubber Switch Boot 1
D 6716 Wiring Harness 1
D 6425 Fuse Holder 1
D 6482 20 Amp Fuse 1
D 7105 3/8" Ring Terminal 2