Operating instructions – SnowEx SP-9500X User Manual

Page 9

Operating Instructions

AUTO-REVERSE “AR” FUNCTION
• If your controller displays “OL” this could indicate a jammed auger.
• To engage the Auto-Reverse “AR” Function:

1. Push the On/Off button to turn controller OFF for 3 seconds
2. Push the On/Off button again to turn power ON. When the machine starts back up, the AR sequence will automatically start and

the auger will reverse for several rotations to clear the jam.

• After a pause of several moments, the auger will automatically return to correct rotation. If the jam is still not cleared, the controller will

again display OL.

• You may repeat Steps 1 and 2 for a second and third time.
• If after the third try the controller displays OL, you must extract the material that is causing the problem.
• Follow all warning directions when clearing jams.

MAINTENANCE
Use dielectric grease on all electrical connections to prevent corrosion at the beginning and end of the season and each time power plugs are
disconnected.
Wash unit after each use to prevent material build-up and corrosion.
Paint or oil all bare metal surfaces at the end of the season.
Apply small amount of light oil to latches as needed.
After first use, tighten all nuts and bolts on spreader and mount.
Grease bearings after washing and after every 20 hours of use.

Vibrator is not designed for continuous duty. Allow motor to cool between long cycle times.
Do not modify vehicle or spreader wiring harness. Doing so will void product warranty.
When servicing is necessary, perform it in a protected area Do not use power tools in rain or snow because
of danger of electrical shock or injury. Keep area well lighted. Use proper tools. Keep the area of service
clean to help avoid accidents.
Never remove spreader with material in hopper.
Disconnect electricity to spreader before servicing.
When replacing parts use only SnowEx parts. Failure to do so will void warranty.
The controller is a solid state electronic unit and is not serviceable. Any attempt to service will void warranty.
There are no serviceable parts in the motor/transmission assembly. Any attempt to service will void war-
ranty.
When pressure washing motor enclosure area, stay at least 36’’ away from motor enclosures.

Store control in cool dry place during the off season.
Vibrator is not designed for continuous duty. Allow motor to cool between long cycle times.
Do not modify vehicle or spreader wiring harness. Doing so will void product warranty.