SnowEx SP-1875 - Manual (Page 15)

15 © Trynex International 2011 (REV A) F50872
Troubleshooting Material Flow
Model # SP-1575/SP-1875
Snowex Diagnostic Test Kit (STK-080) Is Available To Accurately Diagnose Any Issues With Snowex Spreaders.
Call Your Dealer For Details.
Material Does Not Flow
Material Free Flows
Slow Material Flow
Material Obstruction
Increase Auger Speed
Auger Runs Backwards
Material Issue
Check Baffle Length
Turn On Vibrator
Check Baffle Position
Turn On Vibrator
Remove Obstruction
Run 12 Volt To Auger
Circuit On Spreader
Power Cord
18” Correct
Should Touch Hopper
On 3 Sides
Material Issue
Auger Runs Proper
Direction
Material Issue
Auger Runs
Backwards
Material Issue
Replace Vehicle
Harness
Check Connections
At Auger Motor For
Reverse Polarity
Polarity Correct
ReplaceSpreader
Harness