Seed Hawk GRANULAR AND LIQUID TANKS 2010 - Manual (Page 51)

Seed Hawk Manual Granular and Liquid Tanks Page 49
9.3 SPEED SETTINGS
9.3.1 Pulses Per Rev
Pulses per Rev (revolution) are the number of pulses presented to the implement
mounted speed sensor in one revolution of the shaft being monitored. Check
your actuator to determine the correct number of pulses. A 32 tooth sprocket on
the clutch shaft increases the amount of pulses per revolution resulting in more
accurate metering.
9.3.2 Wheel Pulses per 400FT
This is the ground speed calibration number for an implement mounted speed
sensor. The default number is 0.
9.3.3 Speed Calibration
All new systems require a ground speed calibration to ensure accurate area
totals and accurate ground speed readings. To complete the calibration, measure
a course 400 feet long preferably on level ground with a start and finish point.
The drill must be in the down position throughout this procedure.
Note: During the calibration the monitor is counting the number of pulses
produced from the drill mounted sensor. The monitor will display the pulses
counted in 400 feet, which can be greater or less than 400.
Procedure:
1. From the Speed Settings menu Highlight Speed Calibration and press
SELECT.