Seed Hawk GRANULAR AND LIQUID TANKS 2010 - Manual (Page 31)

Seed Hawk Manual Granular and Liquid Tanks Page 29
5.3 FILLING THE LIQUID FERTILIZER TANK
To fill the liquid fertilizer tank:
1. Remove fill cap, 1 FIG. 40, and
attach fill hose from liquid
fertilizer supply source to the
quick coupler.
2. Open fill valve, 2 FIG. 40 and
begin filling tank by starting fill
pump.
3. When tank is near full, shut off fill
pump and close main valve, 3,
FIG. 40.
5.4 LIQUID FERTILIZER APPLICATION RATE
1. Refer to the Calibration section of
this Operator’s Manual to
determine the proper pump
setting. To adjust the pump
setting:
2. Loosen pointer setting nut, 1 FIG.
41.
3. Rotate dial, 2 FIG. 41, to desired
setting.
NOTE: If dial is difficult to turn
by hand, use the supplied
pump setting wrench.
4. Tighten pointer setting nut firmly,
but do not over tighten.
1
FIG.40
3
2
FIG. 41
2
1