RIKON Power Tools 20-100 - Manual (Page 6)

6
Loose Parts in Bag 2
3 3/8” Flat Washers
3 3/8” Lock Washers
3 Mounting Bolts
1 3mm Hex Wrench
1 5mm Hex Wrench
1 8/10mm Open End Wrench
Tools Required for Assembly
Philips Head Screwdriver, Adjustable Wrench, 14mm Open End Wrench and a metric socket set.
1 12/14mm Open End Wrench
2 1/8” Flat Washers
6 1/8”x3/8” Pan Head Screws
1 Blade Adjust Tool
Unpacking Carton and Cleaning
1. Carefully remove all contents from both shipping cartons. Compare contents of the shipping cartons
with the list of contents in this manual. Place parts on a protected surface.
2. Report any shipping damage to your local distributor.
3. Clean all rust protected surfaces (bed, fence, etc.) with a parts cleaning solvent or WD40.
Do not use; gasoline, paint thinner, mineral spirits, etc. as these may damage painted surfaces.
Caution: Cutterhead blades are extremely sharp! Use care when cleaning!
4. Apply a thin layer of paste wax to the milled surfaces of the fence and tables to prevent rust.
5. Set packing material and shipping cartons to the side. Do not discard until machine has been set
up and is running properly.