Adjustments – RIKON Power Tools 20-100 User Manual

Page 12

Figure 15

Figure 16

45º Fence Adjustment

1. Loosen lock handle (A-Fig. 16). Move the

stop plate (F-Fig. 16) out of the way and
position the fence at the 45

angle. Make

sure the fence sits against the stop bolt (G-
Fig. 16).

2. Place a combination square on the fence and

table to confirm a 45

angle setting.

(A-Fig. 17)

3. To adjust, loosen lock nut and bolt (G-Fig. 16),

until a 45

angle is obtained, and tighten lock

nut (G-Fig. 16).

4. Tighten lock handle (A, Figure 16).

4. Place a combination square on the in-feed

table to check that the fence is 90

to the

table. (A-Fig. 15)

5. If fence is not square to table, release lock

handle (A-Fig. 16) and adjust using handle
(C-Fig. 16) until the fence is 90

º.

6. Now that the fence is 90

to the table, adjust

the positive stop screw assembly (E-Fig. 16)
to maintain the 90

position.

7. Retighten lock handle (A-Fig. 16).

Figure 17

Adjustments