RIKON Power Tools 20-100 - Manual (Page 10)

Installing Handwheels
1. Press handwheels (A-Fig. 9) onto shaft,
aligning the slot in the handle with the pin on
the shaft. If necessary, use a hammer with a
block of wood to tap the handwheel
completely onto the shaft.
2. Tighten set screw, (B-Fig. 9).
Depth Limiting Stop
1. Attach depth limiting stop. Thread stop into
steel plate at the rear of the infeed table.
(A- Fig. 10)
Installing Cutter-Head Guard
1. Turn spring knob (A-Fig. 11) approximately
one and one half revolutions counter-
clockwise and hold.
2. Insert guard post into hole in table. Make sure
spring engages slot in guard post.
3. Check for proper operation. Guard must
return fully to fence when released. If guard
does not return fully, remove guard, apply
more tension to spring knob by turning it
another half turn counter-clockwise, and re-
insert guard. If guard closes too quickly and
strikes fence too hard, release some tension
on the spring.
10
Assembly
Figure 9
Figure 10
Figure 11
A
B
A
A