RIKON Power Tools 50-112 - Manual (Page 5)

5
Assembly
341mm
(13-7/16”)
OUTLINE OF
SANDER
2 HOLES
10mm(3/8” Diameter)
68mm
2-21/32”
19mm
(3/4”)
14mm
(9/16”)
Securing Sander Base Assembly to Workbench
Belt and disc sander must be fastened securely to a firm supporting surface such as a workbench.
1. Place sander in operational position on workbench.
2. Place a pencil through the holes in the sander base (42) and mark drill holes in workbench.
3. Remove sander and drill two 10mm (3/8”) dia. holes through the workbench.
4. Align sander base over holes and secure using two 5/16” screws and hex. nuts
Mounting Sanding Disc and Guard
1. Locate sanding disc (7) and peel backing off disc.
2. Align perimeter of sanding disc over plate. When aligned, press sandpaper disc firmly onto
backing disc.
3. Position disc guard (6) onto lower portion of sanding disc so that the mounting holes align.
4. Using a Phillips screwdriver, fasten two pan head screws (found in parts bag) over disc
guard.
Disc (10)
Pad, 6 inch
Sandpaper (7)
Disc Guard