RIKON Power Tools 30-240 - Manual (Page 9)

9
4. Install the idler pulley and drive belts. Simply
slide the pivot post of the idler pulley into the
corresponding hole in the drill press head. The
small drive belt (A-27) is mounted to the motor
pulley and the large drive belt (A-29) is mounted
to the spindle pulley (Figure 9).
Figure 9
A-29
A-27
Assembly
Figure 10
Figure 11
5. Release the locking knobs on the both sides
of drill press head. Release the tension on the
belt by swinging the tension lever from right to left
(Figure 10).
Choose the desired speed by referring to the
speed selection chart under the belt cover.
6. To install the belt cover handle, open the belt
cover and insert the Philliips head screw through
the hole in the center from the inside. Thread the
handle on the outside of the belt cover and tight-
en with a screwdriver (Figure 11).