Wiring diagram maintenance – RIKON Power Tools 10-370 User Manual
Page 19
19
BEFORE CLEANING OR CARRYING OUT MAINTENANCE WORK, DISCONNECT
THE MACHINE FROM THE POWER SOURCE (WALL SOCKET). NEVER USE WATER OR OTHER
LIQUIDS TO CLEAN THE MACHINE. USE A BENCH BRUSH. DO NOT USE COMPRESSED
AIR NEAR BEARINGS. REGULAR MAINTENANCE OF THE MACHINE WILL PREVENT
UNNECESSARY PROBLEMS.
Keep the table clean to ensure accurate cutting.
Keep the outside of the machine clean to ensure accurate operation of all moving parts and prevent
excessive wear.
Keep the ventilation slots of the motor clean to prevent it from overheating.
Keep the inside (near the saw blade, etc.) clean to prevent accumulation of dust.
This machine must be grounded. Replacement of the power supply cable should only be
done by a qualified electrician.
Caution!
WARNING
!
Wiring Diagram
Maintenance
- 10-201 (40 pages)
- 10-305 (24 pages)
- 10-308 (20 pages)
- 10-315 (28 pages)
- 10-321 (52 pages)
- 10-325 (28 pages)
- 10-346 (38 pages)
- 10-350 (32 pages)
- 10-600VS (17 pages)
- 23-400 (22 pages)
- 23-400H (28 pages)
- 25-010 (26 pages)
- 25-010H (32 pages)
- 25-200 (26 pages)
- 25-200H (36 pages)
- 30-100 (24 pages)
- 30-120 (20 pages)
- 30-140 (21 pages)
- 30-240 (22 pages)
- 30-251 (21 pages)
- 34-250 (18 pages)
- 50-112 (18 pages)
- 50-120 (18 pages)
- 50-142 (24 pages)
- 50-150 (18 pages)
- 51-200 (14 pages)
- 60-100 (16 pages)
- 60-200 (16 pages)
- 61-200 (16 pages)
- 61-1250 (18 pages)
- 61-1600 (18 pages)
- 61-2400 (18 pages)
- 62-100 (16 pages)
- 63-100 (16 pages)
- 70-050 (16 pages)
- 70-100 (18 pages)
- 70-300 (28 pages)
- 70-425 (18 pages)
- 70-500 (28 pages)
- 80-805 (22 pages)
- 10-110 (27 pages)
- 10-300 (17 pages)
- 10-320 (22 pages)
- 10-340 (22 pages)