Rhino Shelter SHED-8W X 8L X 8H - Manual (Page 5)

Assembly Instructions
Shed House Style 8 x 8 x 8
V1.0
Do NOT Return Assembly To Dealer or Store. For All Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
upright with the U-bolt and tighten. Do not attach to base
cross rails. Ensure there is no slack in the cable. Slack
can be removed by wrapping the cable around the tie-
down rail.
End Panel Installation
Note: Both End Panels MUST be installed before
installing Main Cover onto frame.
Note that one door has a Full Width opening on each
end.
Step1. Remove Carriage bolts from the Top Crest Rail
and the two Upper Cross Rails. Install End Panel Door
on each end of the Frame assembly.
Step 2. Place the end panel over the first arch and wrap
the material around the arch bringing the slits in the end
panel to the inside of the frame arch. End Door Panels
have pre-cut slits that allow frame members to pass
through so rope pocket is inside unit. Place the top ridge
cross rail pole and the side cross rails through the
material slits and replace the carriage bolts and tighten.
The door end will also require removal of the wind brace
bolts and placement of the wind braces through slits in
the ends panel. Reconnect wind braces with carriage
bolts once end panel is put into place.
Door assembly is drawn over frame by tightening rope
and securing to turnbuckles #22 at the arch foot. Frame
must be secured in position so it does not move as end
doors and main cover are tightened over frame. This
step is key to good fit and to prevent door movement in
wind.
The rope channels should be located inside the unit, with
the frame members passing through the pre-cut slits in
the end panel/door. Replace and tighten the carriage
bolts after putting the end panel into position.
When putting on the doors, adjust the length to make
certain the doors do not drape onto the ground. Adjust
by pulling more or less material over end arch. If pulling
them up puts too much stress on the slit where it goes
over the wind brace, use a sharp knife to cut slit another
inch or two to relieve it. The PE fabric is rip-stop weave
and will only separate where cut.
Step 3. Tie off one end of the rope coming out of the
end panel to a turnbuckle #22. Turnbuckle #22 should
be loosened all the way and the open hook end attached
to the hole in the inside of the end arch foot. Hold the
end of the unsecured rope and apply pressure
downward with a foot to remove excess. Re-adjust
gathered material evenly along door rope. This step is
key to getting a good door fit. Tie off the end off the rope
to a second turnbuckle attached to a hole in the foot of
the end arch on the opposite side. The end panel can
be adjusted further by tightening the turnbuckles.
Pull U-Bolt &
Anchor Loop up on
Arch Base and
Tighten