Alcatel-Lucent Omni 6624 User Manual
Page 77
OmniSwitch 6600 Series Chassis and Hardware Components
Viewing Basic Chassis Information
OmniSwitch 6600 Series Hardware Users Guide
April 2004
page 2-57
Basic Primary Slot and Component Information
To view basic slot and component information for the base chassis only (i.e., no installed uplink or stack-
ing modules), enter the
show cmm
command at the CLI prompt. This command displays the following
information:
•
Model name, also referred to as chassis type
•
Chassis description
•
Alcatel part number
•
Hardware revision level
•
Serial number
•
Manufacture date(s)
•
Current power and operational status
•
Base chassis MAC address
•
ASIC and firmware information
For example:
-> show cmm
CMM in slot 1
Model Name: OS6648 ,
Description: 48PT 10/100 Stack,
Part Number: 902098-10,
Hardware Revision: 210,
Serial Number: 2313283p,
Manufacture Date: FEB 05 2106€,
Firmware Version: N/A,
Admin Status: POWER ON,
Operational Status: UP,
Power Consumption: 40,
Power Control Checksum: 0x0,
MAC Address: 00:d0:95:12:ed:00,
ASIC - Physical:
For complete descriptions of the command output, refer to the OmniSwitch CLI Reference Guide.
Stacked Configurations. You can use the show cmm command to display information for all switches in
a stack, or for a specified switch only. When the show cmm syntax is entered with no specified slot
number, information for all switches displays. When a slot position is specified in the command line
(e.g., 3), information displays for the corresponding switch only. For detailed information on stacked
OmniSwitch 6600 series switches, refer to