Removing uplink and stacking modules, Removing uplink and stacking modules -31 – Alcatel-Lucent Omni 6624 User Manual
Page 51
OmniSwitch 6600 Series Chassis and Hardware Components
Removing Uplink and Stacking Modules
OmniSwitch 6600 Series Hardware Users Guide
April 2004
page 2-31
Removing Uplink and Stacking Modules
To remove an uplink or stacking module from the chassis, follow the steps below:
Anti-Static Warning. Before handling any components, free yourself of static by wearing a grounding
strap, or by grounding yourself properly. Static discharge can damage the switch and the uplink or stack-
ing module.
1
Loosen the two captive screws, located at the left and right sides of the module’s front panel. If neces-
sary, use a Phillips screwdriver to loosen the screws.
Note. Be sure that both captive screws are completely disengaged from the threaded holes in the chassis
before continuing.
Loosening the Captive Screws
EXP
ANSION/ST
ACKING
5 1
5 2
LINK/ACT
LINK/ACT