Lincoln Electric IM954 VANTAGE 500 DEUTZ - Manual (Page 28)

C-2 ACCESSORIES C-2
VANTAGE® 500 DEUTZ
WIRE FEEDER OPTIONS
K2613-1 LN-25 PRO PORTABLE WIRE FEEDER-The
MAXTRAC® wire drive enhances performance, while the
replacement case, and many other upgrade options that can
be installed in less then five minutes aid in the serviceability.
KP1697-5/64 Drive Roll Kit- Includes: 2 polished U
groove drive rolls, outer wire guide and inner wire
guide for solid core wire. (Used on LN-25 Pro)
KP1697-068 Drive Roll Kit- Includes: 2 polished U
groove drive rolls, outer wire guide and inner wire
guide for solid core wire. (Used on LN-25 Pro)
KP1696-1 Drive Roll Kit- Includes: 2 V groove drive
rolls and inner wire guide for Steel Wires. (Used on
LN-25 Pro)
K449 LN-25 Wire Feeder
Portable CC/CV unit for flux-cored and MIG welding.
Includes Gas Solenoid & Internal Contactor.
K126-2 Magnum® 350 Innershield Gun (for LN-25)
For self-shielded wire with 15 ft. (4.5m) cable. For
.062-3/32” (1.6-2.4mm) wire.
KP653-3/32 Drive Roll and Guide Tube Kit (for LN-25)
For .068-3/32” (1.8-2.4mm) cored or solid steel wire.
K1802-1 Magnum® 300 MIG Gun
For .035-.045 (0.9-1.2mm) gas shielded wire.
Includes 15 ft. gun and cable assembly and connector
kit.
KP653-035S Drive Roll and Guide Tube Kit (for LN-25)
For .035-.040” (0.9-1.0mm) solid steel wire.
K487-25 Magnum SG Spool Gun
Hand held semiautomatic wire feeder. Requires SG
Control Module and Input Cable.
K488 SG Control Module
The Interface between the power source and the
spool gun. Provides control of the wire speed and gas
flow. For use with a spool gun.
K691-10 Input Cable (For SG Control Module)
For Lincoln engine power sources with 14-pin MS-
type connection, separate 115V NEMA receptacles
and output stud connections.
PLASMA CUTTING
K1581-1 Pro-cut 80
Cuts mild steel using the 3-phase AC generator power
from the engine driven welder.