Lincoln Electric IM558 Synergic 7 and 7H Water Cooled - Manual (Page 18)

A-11 INSTALLATION
SYNERGIC 7 & 7H
A-11
Wire Reel Dust Shield for K376 50-60 Lb. Wire Reel
Mounting Stand - If the user desires to protect the
wire from falling dirt and dust, there is a shield avail-
able to cover the wire reel. Order part number
S14543. Instructions are included with the kit.
Wire Reel Dust Shield Door for K303 and K376
(when equipped with an S14543 shield) - In
extremely dusty and dirty locations, this door kit can
be added to those units having the shield kit
(S14543). This door kit includes a hinged door and
sliding bottom seal. When these parts are attached to
the reel support per the instructions included, the unit
becomes a completely enclosed housing. Order part
number M11514.
K377 - Small Mounting Stand for Readi-Reel Coils or
10-44 Pound (4.5-20 kg) Spools with 2" I.D. - This
assembly includes a small frame to which is attached
a wire reel spindle similar to the K162 Spindle. The
unit is supplied with the K363 Readi-Reel Adapter for
using the Lincoln "Readi-Reel Electrode Coils".
Without the adapter, the unit is capable of handling
spools with a 2" (51mm) I.D., a 12" (30mm) maximum
O.D., and a 4" (101mm) width. For spools with an 8"
(200mm) O.D., a K468 spindle adapter is available.
The spindle has an adjustable braking system. See
Installation section “Attaching the Wire Reel Stand”
for mounting to wire feed unit.
K378 - Small Mounting Stand for 13-14 Pound
Innershield Coils - This assembly includes the same
smaller frame as used in the K377 and a fully
enclosed canister system for de reeling of the 14
pound (6 kg) coil. This system has a fixed brake for
this coil. See Installation section “Attaching the Wire
Reel Stand” for mounting to wire feed unit.
K659-1 - Gas Guard Regulator - Adjustable flow regu-
lator with removable adjustor key for CO2 and Argon
blend gases. Mounts onto feeder inlet, and reduces
gas waste and arc start "blow" by reducing surge
caused by excess pressure in supply hose.
Install the 5/8-18 male outlet of the regulator to the
5/8-18 female gas inlet on the back panel of the
Synergic 7. Secure fitting with flow adjuster key at
top. Attach gas supply to 5/8-18 female inlet of regu-
lator per See Installation section “Shielding Gas
Connections”.