Lincoln Electric IM592 INVERTEC V200-T - Manual (Page 19)

C-1 ACCESSORIES C-1
OPTIONAL ACCESSORIES
K870 - Foot Amptrol tm for TIG welding. When the
V200-T’s Output Control is in the “REMOTE” position,
the foot Amptrol energizes the output and controls the
output remotely. The Foot Amptrol connects directly
to the 6 pin Amphenol.
K812 - Hand Amptrol tm for TIG welding. When the
V200-T’s Output Control is in the “Remote” position,
the hand Amptrol energizes the output and controls
the output remotely. The Hand Amptrol connects
directly to the 6 pin Amphenol.
K814 - Arc Start Switch - Energizes the output for
TIG welding if remote output control of the amperage
is not desired. It allows on/off TIG welding at the cur-
rent set by the Current Control on the control panel.
When using the Arc Start Switch set the Output
Control to the “LOCAL” position.
Magnum® LA-9 and LA-17/LA-17V TIG Torches -
The following standard Magnum® TIG torches with
one-piece cable may be used with the Invertec V200-T.
• K859-1 LA-9 12.5 ft medium back cap
• K859-5 LA-9 25 ft medium back cap
• K860-1 LA-17 12.5 ft long back cap
• K860-5 LA-17 25 ft long back cap
• K860-9 LA-17V 12.5 ft long back cup;w/gas valve
• K860-13 LA-17V 25 ft long back cup;w/gas valve
NOTE: Each torch requires a quick connector plug
(S22529-1) and strain relief boot (M17255) be
installed onto the cable. Collets, collet bodies, and
nozzles are not included and must be ordered sepa-
rately.
CABLE PLUGS
K852-70 - Cable Plug Kit for 1/0-2/0 cable. Attaches
to welding cable to provide quick disconnect from
machine.
Quick Connect Plug (S22529-1) and Strain Relief
Boot (M17255) - One of each is shipped with the
welder to connect the Magnum LA-9 torch. If you do
not care to interchange these parts between torches
(one of each is required to connect Magnum LA-9 or
LA-17/LA-17V TIG torches with one-piece cable to the
V200-T) you may order additional sets. The quick con-
nect plug provides connection for both gas and weld-
ing current.
TIG Torch Parts Kits - Parts kits are available for the
LA-9 and LA-17/LA-17V TIG torches. These kits
include back cap, collets, collet bodies, nozzles and
tungstens.
Order KP507 for LA-9 torches
Order KP508 for LA-17/LA-17V torches
See publication E12.150 for parts kits breakdown.
Cut Length Consumables - TIG welding filler metals
are available for welding stainless steel, mild steel,
aluminum and copper alloys. See publication C9.10.
INVERTEC V200-T