Lincoln Electric IM694 RED-D-ARC D503K 5+3 HO - Manual (Page 9)

A-2 INSTALLATION A-2
D503K 5+3 HO
Read this entire installation section before you
start installation.
SAFETY PRECAUTIONS
Do not attempt to use this equipment until you
have thoroughly read all operating and mainte-
nance manuals supplied with your machine. They
include important safety precautions, detailed
engine starting, operating and maintenance
instructions and parts lists.
ELECTRIC SHOCK can kill.
•Do not touch electrically live parts
such as output terminals or internal
wiring.
•Insulate yourself from the work and
ground.
•Always wear dry insulating gloves.
------------------------------------------------------------------------
ENGINE EXHAUST can kill.
•Use in open, well ventilated areas or
vent exhaust outside
•Do not stack anything near the
engine.
------------------------------------------------------------------------
MOVING PARTS can injure.
•Do not operate with doors open or
guards off.
•Stop engine before servicing.
•Keep away from moving parts
------------------------------------------------------------------------
Only qualified personnel should install, use or
service this equipment
LOCATION/VENTILATION
The welder should be located to provide an unrestrict-
ed flow of clean, cool air to the cooling air inlets and to
avoid restricting the cooling air outlets. Also, locate
the welder so that the engine exhaust fumes are prop-
erly vented to an outside area.
STACKING
These machines cannot be stacked.
ANGLE OF OPERATION
To achieve optimum engine performance the machine
should be run in a level position.
LIFTING
The equipment lift bale should be used to lift the
machine.
FALLING EQUIPMENT can cause
injury.
•Do not lift this machine using lift
bale if it is equipped with a heavy
accessory such as a trailer or gas
cylinder.
•Lift only with equipment of adequate
lifting capacity.
•Be sure machine is stable when lift-
ing.
------------------------------------------------------------------------
WARNING
WARNING