Lincoln Electric IM757 INVERTEC V350-PIPE - Manual (Page 24)

F-3 DIAGRAMS F-3
V350-PIPE
N.A. WELDING CABLE MUST BE SIZED FOR CURRENT AND DUTY CYCLE OF APPLICATION. N.B. DIAGRAM SHOWS ELECTRODE POSITIVE. TO CHANGE POLARITY, TURN POWER "OFF", REVERSE ELECTRODE AND WORK CABLE AT POWER SOURCE. N.C. INSULATE EACH UNUSED LEAD INDIVIDUALLY.
TO WORK
- +
14 PIN AMPHENOL
N.C.
76 82
K867 UNIVERSAL ADAPTER PLUG
81
SPARE
2 4 41 42 31 32
GND
21 77 75
REMOTE OUTPUT CONTROL
NOT USED ON INVERTEC CONNECT TOGETHER FOR WELDING OUTPUT 24 VAC / 5.5 AMP 24 VAC / 5.5 AMP
42 VAC / 5.5 AMP
115 VAC / 2 AMP
INVERTEC FRAME CONNECTION
N.D.
N.D. FOR WIRE FEEDERS THAT RETURN A SIGNAL FOR WELDING OUTPUT, USE ISOLATION RELAY TO CLOSE LEADS 2 & 4.
2 4
TO K867
ELECTRODE CABLE
WIRE FEEDER VOLTMETER CONNECTION CONNECTS TO (WORK TERMINAL) OF INVERTEC
TO WIRE FEEDER
10K MIN.
Only qualified persons should install, use or service this machine. using the disconnect switch at the fuse box
WARNING
Turn off input power to the Welding Power Source
Before connecting the wire feeder.
ELECTRIC
SHOCK
CAN KILL
INVERTEC POWER SOURCE WITH 115VAC AUXILIARY POWER
S24985
3-1-00
K867 UNIVERSAL ADAPTER / INVERTEC - CONNECTION DIAGRAM