Lincoln Electric IM757 INVERTEC V350-PIPE - Manual (Page 15)

C-1 ACCESSORIES C-1
OPTIONS / ACCESSORIES
• K2176-1 Twist-Mate to Lug Adapter
• K1764-1 Inverter and Feeder Cart
• K1557 Swivel Kit
• K1702-1 Dual Cylinder Kit (For K1764-1)
• K1838-1 Valet Style Undercarriage
Welding Cable Connectors:
• K852-70 1/0-2/0 cable
• K852-95 2/0-3/0 cable
K857 Remote Output Control
K814 Arc Start Switch
K812 Hand Operated Amptrol
K870 Foot Operated Amptrol
Note: All of the above remote controls connect direct-
ly to the 6-pin MS-style connector, with either a K864
or K876 adapter and connect it to the 14 pin wire
feeder MS-style connector. (See Diagram in Section
F-1)
K316L-2 LN-23P
K428, K446, K449 LN-25
K617 (-1 or -2) K618 (-1 or -2) LN-742
K1559-1, K1564-1
LN-10
K1499-1, K1521-1 DH-10
K1587-1 Cobramatic
V350-PIPE
QUICK DISCONNECT PLUGS
A quick disconnect system is used for the welding
cable connections. The K852-70 is designed to
accept a welding cable size of 1/0 to 2/0.
1. Remove 25mm (1 in.) of welding cable insulation.
2. Slide rubber boot onto cable end. The boot end
may be trimmed to match the cable diameter.
Soap or other lubricant will help to slide the boot
over the cable.
3. Slide the copper tube into the brass plug.
4. Insert cable into copper tube.
5. Tighten set screw to collapse copper tube. Screw
must apply pressure against welding cable. The
top of the set screw will be well below the surface
of the brass plug after tightening.
6. Slide rubber boot over brass plug. The rubber
boot must be positioned to completely cover all
electrical surfaces after the plug is locked into the
receptacle.
25 mm
1 in.
WELDING CABLE
BOOT
TRIM
SET SCREW
BRASS PLUG
COPPER TUBE