Avaya 5600 Series User Manual

Page 5

Ethernet Adapter markings is a good first step in determining which agency approvals have been granted.

For inquiries regarding specific certifications, contact your local or regional Avaya representative.

Call: Avaya Publications Center

Voice 1.800.457.1235 or 1.207.866.6701

FAX 1.800.457.1764 or 1.207.626.7269

Write: Globalware Solutions

200 Ward Hill Avenue

Haverhill, MA 01835 USA

Attention: Avaya Account Management

E-mail: [email protected]

For the most current versions of documentation, go to the Avaya support

Web site:

To order copies of this and other documents:

http://www.avaya.com/support

Sources of Information

Gigabit Ethernet Adapter Description

Gigabit Ethernet Adapter For 4600 and 5600 Series IP Phones

Note

Note:

CAUTION:

Operation

Gigabit Ethernet Adapter

Gigabit Ethernet

Adapter

Gigabit Ethernet Adapter

Gigabit Ethernet

Adapter,

Gigabit Ethernet

Adapter's

Gigabit Ethernet Adapter's

For information about the Gigabit Ethernet Adapter or instructions on how to install it, refer to this instruction

booklet packed with the product.

This Gigabit Ethernet Adapter is a mini Ethernet switch with PoE (Power-over-Ethernet) support. It features 3

Ethernet ports: one PoE-enabled 10/100/1000mbps uplink port (connect to the 1000mbps Ethernet wall

socket), one PoE-enabled 10/100mbps downlink port (connect to your IP Phone), and one 10/100/1000mbps

download port (connect to your computer). With this

, you can connect your

computer and IP Phone to the Ethernet network simultaneously.

This

can be used with following IP Phone products:

4602SW, 4602SW+, 4610SW, 4620, 4620SW, 4621SW, 4622SW, 4625SW, 4630SW

5602SW, 5602SW+, 5610SW, 5620SW, 5621SW

Other IP phones may also work but are not supported.

The

will operate with Gigabit Ethernet switches that are fully compliant with the

IEEE 802.3 standard.

the Avaya-Cajun P580 Gigabit card does not support the Carrier Extend Signal and should not be used

in conjunction with this

Failure to use and install as directed could result in injury. No other use of the

is recommended or warranted. At the time of publication, every effort has been made to insure

accuracy of this manual. However, it is possible that 1) some omissions have occurred, or 2) new products

have since been introduced that use the

. If you are unsure concerning the

suitability of this

for a particular application, check your product documentation or

contact your local Avaya representative for assistance.

This Gigabit Ethernet Adapter can only be used with telecommunication and computer equipment, indoors, in

a controlled environment.

Before you deploy the

in your network environment, please disconnect all Ethernet

connections between Ethernet wall socket, IP Phone, and computer, and then switch them off.

Build the Ethernet connection between Ethernet wall socket and the uplink port of the

and check the status of power indicator LED now. If it illuminates, it means the Ethernet wall socket

you connected to supports PoE; if not, please connect the optional power supply to the

power connector. Before you proceed to next step, the power indicator must be illuminated. Build

the connection between your IP Phone and the

IP Phone downlink port now, and

check the state of the power indicator LED again. If it's still illuminated, proceed to next step; if not, please