Elitegroup G900 User Manual - Manual (Page 90)

6.
7.
8.
To install the new memory card, hold the card with its gold edge
connector toward the edge connector slot of the compartment. To
help you orient the cards, the edge connector has been made with
two unequal-length sections. You will only be able to insert the card
in one direction.
Insert the edge connector into the slot. The gold edge connector of
the card should not be visible when the card is fully inserted.
Press the card downward where you should hear an audible click as
the latches of the connector secure the card in place.
Easy to Upgrade HDD Module
The hard drive in your notebook computer is made to be easily swapped
out for upgrading. You should back up your hard drive before attempting
o change the hard drive. Make sure that before you install a new drive,
all the files in your system should be backed up.
This system provides you with two hard drive slots
if your system supports RAID function. If your system does
not support the RAID function, the upper space is reserve for
the Card Reader.
How to Remove your Hard Drive
1.
2.
3.
4.
5.
6.
Power down the system completely. Turn the system over with the
front of the unit facing you.
Remove the two screws that secure the compartment cover and set
them in a safe place.
Slide the HDD cover away from the compartment.
The drive is attached to a special bracket that secures it to the
notebook computer.
Push the HDD slightly in the direction of the arrow as shown in the
illustration to release it from the pins of the drive.
Gently hold the grip of the HDD, lift it up to release from its
compartment.
82