DataComm 70-0022 1X6 Coaxial 4X6 Phone Module with 4 Port Passive Data - Manual (Page 2)

3/14/08 Rev. 1
Instruction / Installation Sheet
DataComm Electronics 1x6 Coax 4x6 Phone 4 Data Module 70-0022
Installation of 4 Port Data Ports
 Pull the Cat 5 or higher rated cables into the HCC panel from one of the
side knockouts.
 Install Cat 5 or higher rated cables from each location in the house to the
4-port passive data ports. Match the color-coding of the wires to the
colors on the 110 IDC connectors.
 The wires should be punched down, using an industry standard punch-
down tool, to the 110 IDC connectors following the T568A wiring
configuration as shown on previous page.
CAUTION
 Never install telephone wiring during lighting storms.
 Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
 Never touch un-insulated wires or terminals unless the telephone
line has been disconnected at the network interface.
 Use caution when installing or modifying telephone lines.
IMPORTANT INSTRUCTIONS
 Read and understand all instructions.
 Follow all warnings and instructions marked on the product.
 Do not use this product near water, for example near a bath tub,
wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.
 SAVE THESE INSTRUCTIONS.
ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT
ETL LISTED
CONFORMS TO
UL STD 1863
ANSI/UL STD 60950-1
CERTIFIED TO
CAN/CSA STD C22.2 NO 60950-1
3026001