DataComm 70-0030 8 Port Passive Data Module for Cat 5e - Manual

10/5/07 Rev. 1
Instruction / Installation Sheet
DataComm Electronics 8-Port Passive Data Module 70-0030
Installation
 Align the mounting pins with holes in the back of the HCC panel and lock
module into place.
 Pull the Cat 5 or higher rated cables into the HCC panel from one of the
side knockouts.
 Install Cat 5 or higher rated cables from each location in the house to the
8-port passive data module. Match the color-coding of the wires to the
colors on the 110 IDC connectors.
 The wires should be punched down, using an industry standard punch-
down tool, to the 110 IDC connectors following the T568A wiring
configuration as shown below.
White / Blue
Blue
White / Orange
Orange
White / Green
Green
White / Brown
Brown
CAUTION
 Never install telephone wiring during lighting storms.
 Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
 Never touch un-insulated wires or terminals unless the telephone
line has been disconnected at the network interface.
 Use caution when installing or modifying telephone lines.
IMPORTANT INSTRUCTIONS
 Read and understand all instructions.
 Follow all warning and instructions marked on the product.
 Do not use this product near water, for example near bath tub, wash
bowl, kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.
 SAVE THESE INSTRUCTIONS.
ONLY LICENSED PROFESSIONALS SHOULD INSTALL THIS PRODUCT
DataComm Electronics, Inc.
6349 Peachtree St.
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommelectronics.com
ETL LISTED
CONFORMS TO
UL STD 1863
ANSI/UL STD 60950-1
CERTIFIED TO
CAN/CSA STD C22.2 NO 60950-1
3026001