DataComm 70-0026 4 x 16 RJ45 Phone Module - Manual

10/11/07 Rev. 2
Instruction / Installation Sheet
DataComm Electronics RJ45 Telephone Module 70-0026
Step 1
 Pull the telephone wires into the HCC panel from top or one of the side
knockouts.
 Using the black push pins, install the 70-0026 RJ45 telephone module in the
HCC panel. Install the cable from the telephone company demarcation point to
the 110 IDC marked from Telco. This will activate line 1, line 2, line 3 and line 4
on the RJ45 ports.
 The wires should be punched down, using an industry standard punch-down tool,
to the 110 IDC connectors following the T568A wiring configuration as shown
below.
 Line 1 is Blue, Line 2 is Orange, Line 3 is Green and Line 4 is Brown.
 A RJ31X port is provided for line 1 seizure by security system.
Step 2
 Install RJ45 plugs (purchased separately – DCE part #20-5703) on all Cat 5e
wiring home runs to the HCC panel.
 Be sure to wire the RJ45 plugs per the RJ45 plug instructions. Mis-wired RJ45
plugs will create a short or no dial tone.
 Once all RJ45 plugs are installed on the home runs, determine which telephone
jacks in the house will be line 1. To connect line 1, insert the RJ45 plug on the
Cat 5e home run into RJ45 ports labeled line 1 on the telephone module. Each
of these home runs will now be connected to line 1.
 To connect line 2, use same instruction as line 1 and use line 2 labeled RJ45
ports.
 To connect line 3, use same instruction as line 1 and use line 3 labeled RJ45
port.
 To connect line 4, use same instruction as line 1 and use line 4 labeled RJ45
port.
White / Blue
Blue
White / Orange
Orange
White / Green
Green
White / Brown
Brown
INSTRUCTIONS ARE CONTINUED ON THE BACK SIDE OF THIS PAGE
DataComm Electronics, Inc.
6349 Peachtree Street
Norcross, GA 30071-1725
888.223.7977
770.662.8205
www.datacommelectronics.com