Brocade Universal Four Post Rack Kit Installation Procedure (Supporting VDX 6740T) - Manual (Page 9)

Universal Four-Post Rack Kit Installation Procedure 9 of 20
53-1002944-01 Rev.B
Installing the switch in the rack
Complete the following steps to install the switch in the rack.
1. Position the switch in the rack, as shown in Figure 4 , providing temporary support under the switch until the rail
kit is secured to the rack.
2. Attach the right front bracket to the right front rack post using two 10-32 x 5/8-in. panhead screws and two
retainer nuts. Use the upper and lower holes in the bracket.
3. Attach the left front bracket to the left front rack post using two 10-32 x 5/8-in. panhead screws and two
retainer nuts. Use the upper and lower holes in the bracket.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs).
FIGURE 4 Positioning the switch in the rack
1 Screws, 10-32 x 5/8-in., panhead Phillips 2 Retainer nuts, 10-32