Brocade Universal Four Post Rack Kit Installation Procedure (Supporting VDX 6740T) - Manual (Page 12)

12 of 20 Universal Four-Post Rack Kit Installation Procedure
53-1002944-01 Rev.B
Attaching the rear brackets to the rack posts
Complete the following steps to attach the rear brackets to the rack posts.
1. Attach the right rear bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two
retainer nuts, as shown in Figure 7 . Use the upper and lower holes in the bracket.
2. Attach the left rear bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer
nuts. Use the upper and lower holes in the bracket.
3. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lbs (29 cm-kgs).
FIGURE 7 Attaching the rear bracket to the rack post
1 Screws, 10-32 x 5/8-in., panhead Phillips 2 Retainer nuts, 10-32