Brocade VDX 8770-8 Two-Post Flush and Mid-Mount Rack Kit Installation Procedure - Manual (Page 6)

6 of 8 Brocade VDX 8770-8 Two-Post Flush and Mid-Mount Rack Kit Installation Procedure
Publication Number: 53-1002668-01
FIGURE 3 VDX 8770-8 installed flush in a two-post rack
4. Secure the switch to the posts using six 10-32 screws with square-cone washers, three screws for each
mounting bracket attached to the switch. Tighten the screws to 32 in-lb (36.86 cm-kg)
NOTE
Screws, clip nuts, and retainer nuts for mounting the switch to the rack are located in the switch hardware
accessory kit.
Mounting the switch in a mid-mount configuration
1. Dismount the rack ears from the front edge of the switch and remount them approximately halfway back along
the sides of the switch, using the 10-32 x .31 screws provided in the kit. Refer to Figure 4 .
2. Maneuver the lift with the switch in front of the rack and adjust the height to match the saddle.
1 Screw locations (opposite side similar)