Boltek LD-350 User Manual
Page 7
I N S T A L L A T I O N
2
Quick Start
1) Connect the USB cable from your computer USB port to the USB connector of your
LD-350.
2) Plug in the AC power adapter into the lead of the LD-350 and into an AC outlet. Turn
on the LD-350. The two yellow LEDs should blink three times, then the unit will beep and
illuminate the indicator lights for 2 seconds.
3) After the power is turned on, the USB drivers for the LD-350 should automatically
install if there is an active internet connection on the computer. If there is no internet
connection, the USB driver install program can be found on the Boltek Driver CD-ROM
under:\LD350_USB\.
4) Connect the antenna cable to both the LD-350 and the antenna. Hold the antenna a few
feet from a computer monitor or television. (A laptop computer display may not produce
enough noise.) The LD-350 should detect the radio frequency noise from the monitor as a
constant stream of noises and/or strikes. By moving the antenna you should be able to
find a position that produces strikes. Yellow strike dots should appear on the map display.
Rotating the antenna should change the strike direction.
5) Mount the antenna away from televisions, computer monitors and other sources of
noise.
LD-350 Connection Diagram
(with optional LTS-3 Timestamp)