Boltek RLO-10 Relay Interface For LD-250 - Manual

©2012 BOLTEK CORP RLO-10 LD-250 Install Instructions 20121002
RLO-10 Relay Output Module
For the Boltek LD-250 Lightning Detector
Description
The RLO-10 is an optional relay output module for the Boltek LD-250 Lightning Detector. The
RLO-10 provides a means for connecting customer supplied equipment to the LD-250's Close
Storm Alarm, Severe Storm Alarm, and Strike indicator. Each of the three relay outputs is a
normally open solid-state contact which closes whenever the respective alarm is activated, as
indicated by the LD-250's front panel LED's. The RLO-10 uses solid-state relays capable of
switching up to 50VDC or 35VAC at up to 1.5 Amps.
Installation
Remove the top cover of the LD-250 by removing
the four cover screws. Locate the relay connector at
the front of the unit near the red alarm indicators.